CE Certification Agricultural Wide Angle Tractor Factory Supply 6 Spline 540 Pto Drive Shaft for Bush Hog with Yoke Adapter Parts

Overview

Basic Info.

Model NO.	PTO Drive Shaft-YY
Appearance Shape	Round
Journal Surface Roughness	0.63-0.16μm
Transport Package	Wooden Box
Trademark	no brand
Origin	China
HS Code	848390009
Production Capacity	5000PCS/Month

Product Description

CE Certification Agricultural Wide Angle Tractor Factory Supply 6 Spline 540 Pto Drive Shaft for Bush Hog with Yoke Adapter Parts

Product Description

PTO drive shaft
Brand New Replacement PTO shaft for Finish Mowers, Tillers, Spreaders, Hay Tedders and many more applications.

PTO is a series 4, rated for 40HP it has 1-3/8" 6 spline push pin on both ends for easy installment. Complete with safety shield, The PTO measures 43" from end to end and has an 58" maximum extended length.

These PTO shafts fit the following Finish Mowers:

Bush Hog: ATH 600 and ATH 720, ATH 900, FTH 480, FTH 600, FTH 720, MTH 600, MTH 720 Series Mowers;

Landpride: FDR1548, FDR1560, FDR1572, FDR1648, FDR1660, FDR1672, FDR2548, FDR2560, FDR2572, AT2660, AT2672 Series Mowers;

Kubota: BL348A, B342A; Caroni TC480, TC590, TC710, TC910 with spline Input Shaft;

Ever-power most late models with splined input shafts, early models had some with smooth input shaft;

Installation InstructionsPTO SHAFT INSTALLATION INSTRUCTIONInstall assembly1 press-fit plastic pipe and plastic cap,2 fill the groove on the horn with oil3. Slide the nylon bearing into the groove 4. Align nylon bearing and plastic protective coverDisassembly1. remove the nylon bearing clamp (three places) with a screwdriver, and then separate the steel pipe and plastic protective cover.2. Take off the nylon bearing from the groove of the yokes.3. repeat the above-mentioned steps for the other side.
SHORTENING THE PTO DRIVESHAFT
1. Remove the safety shield.
2. Shorten the inner and outer tubes according to the required length, and the inner and outer tubes shall be shortened by the same length at one time
3. Deburr edges of the drive tubes with a file and remove all filings from the tubes.
4. Shorten the inner and outer plastic pipes according to the required length, and the inner and outer plastic pipes shall be
shortened by the same length at one time.
5. Grease the internal drive tubes and reassemble them with a safety shield.
Check the minimum and maximum length of the driveshaft installed on the machine. In working condition, the drive tubes should overlap 2/3 length and the plastic tube should never be separated